Introduction to Radio Instruments
UJPT, E2-C2, ADV, & IUT RIFP-01
C.
Determine entry
1.
Visualize a straight line on HSI from aircraft heading to center of
instrument
Sg 10, fr 6, pg 1
Sg 10, fr 5
Heading Index
TEARDROP SECTOR
PARALLEL ENTRY SECTOR
Turn in shortest direction to
Turn left to parallel the
heading 30 degrees less
outbound course
than the outbound course
70
20
110
20
180
DIRECT ENTRY SECTOR
Turn right to the
outbound course
STANDARD HOLDING PATTERN ENTRY
HOLDING ENTRY PROCEDURE (Standard)
APPROACH PLATE - HOLDING ENTRY DEPICTION
Sg 10, fr 6, pg 2
Heading Index
TEARDROP SECTOR
PARALLEL ENTRY SECTOR
Turn in shortest direction to
Turn right to parallel the
heading 30 degrees more
outbound course
than the outbound course
70
20
110
20
180
DIRECT ENTRY SECTOR
Turn left to the
outbound course
NONSTANDARD HOLDING PATTERN ENTRY
HOLDING ENTRY PROCEDURE (Nonstandard)
2.
Visualize appropriate entry procedure plot superimposed on top
of the HSI and locate the holding radial to determine entry
procedure to be used
NOTE: If the holding radial is within +/- 5 degrees of the entry
plot quadrant division points, either entry procedure associated
with the point may be used. The most appropriate entry is
determined by consideration of known wind, holding airspace,
etc.
(8-97) Change 1
Page 1-33
Previous Page
