T-45C TS, ADV, & IUT RIFP-04
TACAN\VOR\ILS\PAR\ASR Approach Procedures
c.
Extend speed brakes and establish a descent
rate to reach MDA before MAP
d.
Report FAF with gear (ATC)
e.
Report landing checklist complete (ICS)
2.
At MDA
a.
Maintain approach course
b.
Monitor clock for MAP
NOTE: The timing from the FAF to the MAP is
based on ground speed.
C.
VOR approach without published FAF: IAF to MAP
1.
IAF station passage outbound to wings level
inbound on course
NOTE: When departing the IAF, use the same
procedures as you would for VORs with published
FAFs.
2.
Wings level inbound to MAP
NOTE: Since this type of approach has no FAF, the
procedures performed from the FAF inbound on an
approach where there is a FAF are initiated and
performed in the same sequence when the aircraft
roles wings level inbound on course with exception
of the timing inbound, which is excluded.
a.
Roll out of penetration/procedure turn wings
level on final approach course inbound
b.
Transition to landing configuration with speed
brakes extended and establish an on-speed
descent rate to reach MDA before MAP
c.
Report procedure turn inbound with gear (ATC)
if required
(5-99) Original
Page 4-14
Previous Page
