T-45A UJPT, E2-C2, ADV, & IUT Eng-24
Engine Start Procedures
PROGRESS CHECK
Question 1 -- 1.4.1.1.2
What is the source of electrical power to the
ANSWER: 28 VDC essential services bus
Question 2 -- 1.4.1.1.2
Explain the indications of the GTS and ROTATION
advisory lights.
ANSWER: The GTS light indicates that the gas
turbine starter has started and has reached its idle
speed of 86%. The ROTATION light indicates that
the engine N1 shaft is rotating in the correct direction
with a shaft speed > 100 rpm.
III. Unacceptable conditions during engine start
Sg 3, fr 1
1.5.3.1.2.3
Lesson Organization
A.
EGT
1.
High
a.
Maximum starting: 550 degrees C;
maximum overshoot of 20 degrees C
for 10 seconds
b.
Slowly climbing EGT with stagnated
rpm below 52% (hung start)
c.
Any very rapid climb in EGT that
appears likely to exceed
550 degrees C (hot start)
NOTE: Wind blowing up the tailpipe,
extremely high ambient temperature,
and starting a hot engine may cause
higher than normal EGT indications.
Page 24-16
(8-03) Original