ILS Procedures
T-45C IUT BIFP-06
II.
ILS approach procedures 2.9.4.6.2
Sg 2, fr 2
INTRODUCTION TO RADIO
A.
Initial entry to localizer intercept
INSTRUMENTS
1.
Procedure
* Elements of an ILS approach
* ILS approach procedures
a.
Tune and identify the ILS frequency,
select ILS steering and enter inbound
course
Sg 2, fr 3
b.
Select MKR and VOR on COMM panel
NOTE: It is recommended that when
flying an ILS approach the LOC audio
signal be selected.
c.
Transition to landing configuration with
speed brake retracted (5-7 miles prior
to glidepath interception) and to on-
speed within 3-5 miles, trim
ILS APPROACH PROCEDURE
(PLAN VIEW)
(1)
Reduce power (extend speed
brakes if necessary)
Sg 2, fr 4
(2)
Lower gear and full flaps/slats
passing 200 KIAS
(3)
Correct attitude for resultant lift
change from flaps/slats
ILS APPROACH PROCEDURE
(4)
Retract speed brakes, if used, and
(PROFILE VIEW)
adjust power
Sg 2, fr 5
(5)
Establish an attitude reference
COMM
VOR TACAN MKR
HOT
and power setting for on-speed
MIC
C
O
1
2
COLD
M
RCVR
ICS
N
M
A
O
L
+
R
T
M
level flight condition
COMM CONTROL PANEL
NAV
110.10
TEST
VOL
(6)
Trim as required throughout
PWR
OFF
D
N
maneuver
OFF
VOR/ILS PANEL
MFD -- HSI
COCKPIT ILS NAVIGATION SETUP
(7)
Intercept and maintain localizer
course
(4-01) Original
Page 6-9
Previous Page
