T-45C TS, ADV & IUT EMFP-08
Electrical and Indicator Emergency Procedures
PROGRESS CHECK
Question 8 -- 1.8.1.8.1.2
How can you identify a failed WARNING/CAUTION light?
ANSWER: Select MASTER TEST switch to LIGHT TEST.
VI. Multi-Function Display (MFD) failure
Sg 9, fr 2
Lesson Organization
A. MFD
ELECTRICAL AND INDICATOR
EMERGENCY PROCEDURES
1.
MFD failure
* Electrical system
failures
* Pitot static malfunctions
a.
Indications
* ECS failures
* OBOGS contamination/failure
* CWS failure
(1) Blank screen
* MFD failure
(2) Blinking screen
Sg 9, fr 3
MFD Failure
(3) Stuck button(s)
(4) Multiple anomalies
b.
Procedures
(1) Check position of OFF/D/N, BRT, and
CONT knobs for correct setting for light
conditions
(2) Cycle OFF/D/N knob and if problem is
still there, turn affected MFD off
Sg 9, fr 4
Display Power Switch
(3) Select BIT page to check equipment status
(4) Set display power switch to RESET
(5) Set display power switch to ORIDE for
generator power loss to power LH MFD
from 28 VDC essential bus
Original (9-98)
Page 8-15
Previous Page
