T-45C TS, ADV, & IUT CO-03
Multi-Function Display and Navigation System Operation
b.
If the alignment QUAL is not
decreasing or the system is not
tracking four satellites, GPS SAT,
waypoint zero must be entered
2.
Waypoint zero entry: Enter waypoint zero
Fig 3: Waypoint Data Display
latitude and longitude. Unless waypoint
zero is going to be used for CCIP bombing,
elevation doesn't need to be entered.
MVAR only needs to be entered if it is
wrong
3.
Fifty seconds after entering waypoint zero
verify that the QUAL is decrementing on the
aircraft data display
NOTE: You don't need to monitor this
display if the QUAL number is decreasing
and the GPS is tracking four satellites.
B. BINGO and LAW setting: the low altitude
Fig 4: ADI Display
warning (LAW) and BINGO settings are
displayed and changed from the ADI display
1.
The low altitude warning, LAW, defaults to
500 feet and the BINGO, BNGO, defaults to
900 pounds on start
2.
The LAW and BINGO can be changed in
two ways on the ADI display or with the
DEP on the HUD
a.
ADI data entry: select desired
parameter, LAW or BNGO and use the
increment or decrement number to
change the setting
(1) BNGO can be set between 0 and
3,000 pounds in 100 pound
increments
(2) LAW can be set between 0 and
5,000 feet in 10 foot increments
(10-99) Original
Page 3-5
Previous Page
