T-45A UJPT, E2-C2, ADV, & IUT Eng-26
Engineering Review
6.
When RPM and EGT stabilize, check:
Overlay 7
Idle Speed Indications
a.
All warning/caution panel lights - OUT
EXCEPT HYD 2 PRESS, CANOPY (if
open), and OXYGEN
b.
RPM - NOTE, APPROXIMATELY
52%
c.
EGT - NOTE, 450 DEGREES C
MAXIMUM
D.
Post-start
1.
Throttle - ADVANCE SLOWLY TO
70% RPM.
CAUTION: Following a start, do not
advance the throttle rapidly before the
bleed valve closes, as there is a
possibility that the engine will overheat.
Once the bleed valve is closed there are
no restrictions on the rate of throttle
movement.
2.
FUEL CONTRL switch - MANUAL
a.
MANUAL FUEL advisory light
illuminates
NOTE: Engine rpm may decrease by
up to 6%.
3.
FUEL CONTRL switch - NORMAL
a.
MANUAL FUEL advisory light goes out
and ensures previous rpm is achieved
4.
HYD 2 RESET button - PRESS
Check that HYD 2 PRESS caution light
goes out and hydraulic pressure indicated
in normal range
Page 26-92
(8-03) Original
Previous Page
