|
| T-45C TS INav-07
Interpretation of High Altitude Instrument Approach Plates
3.
Holding patterns
Sg 2, fr 16
Holding Patterns
NOTE: Holding procedures and plate depiction standards for
DoD GPS approaches have not (at this time) been specifically
stated.
a.
Arrival holding pattern
(1)
Use until you are cleared to proceed beyond IAF
onto approach
(2)
Thin solid line with notations indicates inbound/
outbound headings and direction of pattern
(clockwise or counterclockwise)
(3)
Provides DME limits for TACAN, VORTAC, and
VOR/DME approach, otherwise standard holding
limits apply (separate VOR and TACAN holding may
be depicted on the same plate)
(4)
Entry diagram found in upper right corner of
planview
(a)
Use for transitioning from route or feeder
facility to arrival holding pattern
(b)
Same pattern as depicted on planview
(c)
Headings given on diagram are inbound
headings to the IAF
NOTE: "Holding in lieu of procedure turn"
pattern not used on high altitude approach
plates.
b.
Missed approach holding pattern
Sg 2, fr 18-20, p3
(1)
Use after executing a missed approach
Missed Approach
Holding
(2)
Dashed line with notations indicates inbound/
outbound headings and direction of pattern
(clockwise or counterclockwise)
(3)
Limits will be specified only if pattern nonstandard,
or DME fixes may be shown
(2-02) Original
Page 7-8
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |