TACAN and VOR Procedures
T-45C TS, ADV, & IUT RIFP-02
5.
Maintain intercept heading to lead point and then
complete intercept of desired course
B.
30-degree angle of intercept
1.
Tune and identify station
2.
Set desired course in course selection window
3.
Look from desired course to head of the bearing
pointer used and 30 degrees beyond (this is your
intercept heading)
4.
Turn aircraft to the intercept heading
5.
Maintain intercept heading to lead point and then
complete intercept of desired course
C.
Immediately after station passage
1.
Turn to parallel desired course
2.
Set desired course in course selection window
3.
Look from tail of the bearing pointer used to desired
course and an equal number of degrees beyond, but
not more than 45 degrees (this is your intercept
heading)
4.
Turn aircraft to the intercept heading
5.
Maintain intercept heading to lead point and then
complete intercept of desired course
D.
45-degree angle of intercept
1.
Tune and identify station
2.
Set desired course in course selection window
3.
Look from tail of the bearing pointer used to desired
course and 45 degrees beyond (this is your
intercept heading)
Page 2-7
(5-99) Original
Previous Page
