FFP-07
Division Parade Formation
(1) Stabilize outside lead’s radius of turn at a parade turn-
away position, approximately 200 ft and slightly stepped
up on lead
PRESS ENTER OR SELECT NEXT FOR 2ND OVERLAY.
(2) When cleared by lead, move below and behind flight to
return to rendezvous bearing on inside of turn
PRESS ENTER OR SELECT NEXT FOR 3RD OVERLAY.
(3) Join-up, moving into open slot
b.
Any aircraft behind underrunner: complete rendezvous and
leave room for underrunner to join in his respective position
when cleared by lead
c.
Lead: if necessary, continue turn past 180 degrees until
underrunner has joined up
3.
Common error by Dash-2, Dash-3, or Dash-4 during division
underrun
a.
Problem: potential midair due to failure to recognize
parameters for underrun
Correction: scan airspeed and relative motion to all preceding
aircraft
b.
Problem: potential midair due to not stabilizing in underrun
position and not waiting for lead’s direction to cross back over
for join-up
Correction: stabilize in underrun position and await lead’s
direction to cross back over for join-up
Page 7-21
(10-95) Original
Previous Page
