T-45C TS, ADV & IUT ONFP-01
Low Level Waypoint Navigation
a.
Waypoint sequence string entered on waypoint DATA
display
b.
Select SEQ DEP
c.
Enter number of first waypoint in string on the DEP and
press enter, repeat for remainder of waypoints, up to 10
d.
If less than 10 waypoints select SEQ DEP again
e.
When tenth waypoint entered, string automatically entered
f.
Individual waypoints can be repeated in the string
Note: The first waypoint may also be the last waypoint,
but you must ensure the first waypoint in the string is
selected, or the AUTO sequence will disconnect after it
is first overflown.
g.
Select CLR on the DEP to remove incorrect waypoint
scratch pad entry, if incorrect waypoint entered in string
the entire string must be reentered
3.
Waypoint sequential string selection
a.
Select SEQ option on HSI display
b.
Waypoint string appears as dashed line on HSI display
when sequence (SEQ) selected on HSI
D.
Waypoint offset programming
1.
Waypoint offset defined by bearing, range and elevation from an
entered waypoint and is shown as a "+" on the HSI display
2.
Waypoint offset may be entered for each entered waypoint
3.
Waypoint offset data entered on the waypoint DATA display
4.
Waypoint offset data entry
a.
Select desired tactical waypoint
b.
Select RNG O/S, BRG O/S or ELEV O/S option (offset
data is only shown with range greater than zero)
5.
If waypoint position data is changed after an offset waypoint is
entered, the offset data will automatically reset to zero
E.
Low Altitude Warning (LAW)
1.
LAW setting displayed on ADI display
Page 1-8
(4-03) Original
Previous Page
