T-45C TS, ADV & IUT ENG-27/ENG-28
Engineering Review
(3) FUEL CONTROL switch - NORMAL
M FUEL advisory light goes out
and ensure previous RPM is achieved
(4) HYD 2 RESET button - PRESS
Check that HYD 2 caution light goes out
and hydraulic pressure indicates in normal
range
(5) Hydraulic pressure - 3000 PSI
(6) Throttle - IDLE, CHECK EGT AND RPM,
ENSURE BLEED VALVE CLOSED
NOTE: Bleed valve closure can be
confirmed by noting RPM increased
approximately 3% and EGT decreased by
50 degrees C from previous indications.
4.
Unacceptable conditions during engine start
Sg 14, fr 16
Unacceptable
Conditions During
a.
EGT
Engine Start
(1) High
(a) Maximum starting: 550 degrees C;
maximum overshoot of 20 degrees C
for 10 seconds
(b) Slowly climbing EGT with stagnated
rpm below 52% (hung start)
(c) Any very rapid climb in EGT that
appears likely to exceed 550 degrees
C (hot start)
NOTE: Wind blowing up the tailpipe,
extremely high ambient temperature,
and starting a hot engine may cause
higher than normal EGT indications.
(9-98) Original
Page 27-145
Previous Page
