T-45C TS, ADV & IUT ENG-27/ENG-28
Engineering Review
(d) At starter cut-out speed (45% rpm)
Sg 14, fr 14
Engine Start Sequence
(i)
Start control unit shuts down GTS
and GTS and READY advisory
lights extinguish
(ii) Engine ignition units deenergize
(iii) Generator comes on-line, and
GENERATOR warning light out
(may not occur until after N2 rpm
above 61%)
(6) When RPM and EGT stabilize, check:
(a) All warning/caution panel lights - OUT
EXCEPT HYD 2, CANOPY (if open or
unlocked), AND OXYGEN
(b) RPM - NOTE, APPROXIMATELY
52%
(c) EGT - NOTE, 450 DEGREES C
MAXIMUM
Sg 14, fr 15
e.
Post-start
Engine Start Sequence
(1) Throttle - ADVANCE SLOWLY TO 70%
RPM
CAUTION: Following a start, do not
advance the throttle rapidly before the
bleed valve closes, as there is a
possibility that the engine will overheat.
Once the bleed valve is closed there are
no restrictions on the rate of throttle
movement.
(2) FUEL CONTROL switch - MANUAL
M FUEL advisory light illuminates. Note
engine RPM may decrease by up to 6%
(9-98) Original
Page 27-144
Previous Page
