 |
|||
|
|
|||
| ||||||||||
|
|  STUDENT ACTIVITY GUIDE
TOPIC:
T2 Hydraulic System Familiarization
1.
The utility hydraulic system supplies fluid to the _______________, _______________,
_______________, _______________, and_______________ _______________
2.
The utility hydraulic system reservoir is located in the _______________ ______________
_____________.
3.
The return line filter located in the _______________ _______________
_______________ incorporates a red indicating pin to tell when the system has become
contaminated.
4.
A hydraulic pressure indicator located the instrument panel will show normal pressure
indications of _______________ to _______________ psi.
5.
With a full fuel load on the aircraft, the main gear strut extensions should be __________
inches and the nose gear strut extension is __________ inches.
6.
Minimum nose wheel shimmy damper rod extension is __________ inches.
7.
A landing gear control handle is located on the left side of the instrument panel in each
cockpit. Movement of the handles __________ __________ unlocks the landing gear
uplocks or downlocks. The landing gear selector valve is _______________ positioned to
direct fluid to raise or lower the landing gear.
8.
The landing gear handles are 'Locked in the down position while on the ground by the
__________ __________ __________ to prevent accidental gear retraction.
9.
The landing gear hydraulic override switch allows the landing gear to free fall in the event
of a _______________ _______________ malfunction.
10. To Preflight the tailhook system, ensure that the hook is _______________ snubber-
actuator pressure reading gage is _______________ and the ________________
_______________ is at the _______________ ring.
11. The speedbrakes are electrically controlled by a switch on the __________ _________.
12. The speedbrakes may be stopped at _______________ positions only during the
_______________ cycle.
13. A speedbrake dump handle is located on the left console in the forward cockpit only.
When pulled, its main purpose is to __________ position the selector valve to __________
the speedbrakes when __________ power is lost. If __________ __________ is also lost,
the speedbrakes will go to a trail position.
5-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals