T-45C TS, ADV, & IUT CO-02
Engine Start and Poststart
PRESENTATION
I.
Prestart checks 1.3.6
NOTE: The NATOPS prestart checklist is not
duplicated in this lesson guide. Use the Pilot's
Pocket Check List for prestart checks. Additional
information about the Prestart Checks is contained
in the NATOPS manual.
A. NATOPS step 2. Seat - ADJUST: The three
position seat height switch is spring-loaded to
the center position. Holding the switch forward
lowers the seat and holding the switch aft raises
the seat
B. NATOPS step 3. ICS - CHECK: Depress the
microphone switch to check the ICS, MIC switch
on the communications control panel is in
COLD. Moving the microphone switch up or
down will transmit on the comm 1 or comm 2
radio respectively
C. NATOPS step 6. Warning/caution/advisory
lights panel - ENSURE THE FOLLOWING ON:
SKID Advisory ON: If the SKID advisory is not
on, check that the ANTI-SKID switch in both
cockpits is ON. If a Warning/caution/advisory
light is not illuminated it can be checked by
placing the LIGHT TEST/TONE TEST switch in
LIGHT TEST
AC INV - on aircraft 165457 and up and on
aircraft 165456 and below with AFC 199
incorporated the AC INV caution light will not be
illuminated
D. NATOPS step 9. MASTER test switch - LIGHT
TEST: Selecting LIGHT TEST illuminates all the
warning, caution, advisory lights and tests the
fire warning system
Page 2-4
(10-99) Original
Previous Page
