T-45C TS, ADV & IUT ONFP-02
Review of the ONav FTI
e.
Perform all actions required over/immediately
after checkpoint
(1) Turn
(2) Check time
(3) Check fuel
(4) Check engine instruments
(5) Initiate corrections
II.
Determination of Position 1.7.7.4.4
Sg 2, fr 2
Lesson Organization
What are the primary instruments used to determine
REVIEW OF THE ONAV FTI
?
position on the low level route?
*
Procedures for visual low-level navigation
Determinationofposition
*
*
Time corrections
*
Course corrections
*
Low altitude attacks
*
Two plane road reconnaissance,
low-level route
ANSWER: The elapsed time clock and HSI
*
Hazards of low altitude flight
*
Safety concerns of low altitude flight
*
Deteriorating weather
*
Flying bingo profile
*
Entry/exit communication
*
System Navigation
INSTRUCTOR NOTE:
Video can not be stopped once started. The "Entire route" video
Sg 15, fr 2
is 19 minutes long. Selection two, "Individual checkpoints",
ONAV LOW-LEVEL
Route Video Menu
displays a menu that allows selection of individual portions of the
route. Each of the individual checkpoint videos is from 16
SECTION MANEUVERING
seconds to 1 minute 45 seconds long.
ONav LOW-LEVEL ROUTE
1. Entire route (19 minutes)
2. Individual checkpoints
3. Continue with lesson
Please select
A.
Use elapsed time for on-course locations
Sg 15, fr 4
1.
Use compass for heading
Individual Checkpoints
Video Menu
2.
Use clock for elapsed time
INDIVIDUAL CHECKPOINTS MENU
1.
Entry point (1 min)
2.
Point B (1 minute)
B.
Go from clock to chart to ground to locate course along
3.
Point C (1 minute 40 seconds)
4.
Point D (1 minute 45 seconds)
ground
5.
Point E (55 seconds)
6.
Point F (1 minute)
7.
Initial point (16 seconds)
8.
Target (16 seconds)
1.
Locate landmark in conjunction with elapsed time on
9.
Return to main menu
Please select
chart then look for it on the ground
(4-03) Original
Page 2-8
Previous Page
